Throttle Postition Sensor Adjustment:

For this modification you need to put the bike into Diagnostic Mode:

To access DIAG mode:

Switch off Engine Run switch, switch OFF Key switch. Press both SELECT & RESET buttons and then switch ON Key switch. Keep SELECT & RESET buttons pressed for at least 8 seconds. Display then changes to "DIAG". Release SELECT & RESET buttons. Select Diag mode by pressing again both SELECT & RESET buttons. Select code below by pressing SELECT (up) or RESET (down).

On the digital display select 01 (throttle position) and make a note of the number on the screen. It should be between 15 - 17.

Now locate the throttle sensor, its on the left hand side of the bike behind the cylinder.

Slacken the two bolts on the sensor

If you rotate the sensor clockwise/ anti clockwise you will see the number of the digital display increase and decrease.

Increase the value to 26 (max is 27).

DISCLAIMER: YOU DO THIS AT YOUR OWN RISK AND MAY VOID THE MANUFACTURERS WARRANTY.